Keeping Shelf Pin Holes Clear

Article - June 17, 2008

This week’s question comes from Avraham. He writes:
In the past when I’ve built bookshelves and entertainment centers I drill all of the holes for the shelf pins before I assemble the whole piece. However, after finishing the piece with polyurethane the holes get filled with finish and I end up re-drilling them all. This takes a whole lot of time and I’m assuming there’s a better way. What do you do to avoid having the shelf pin holes clog with finish?

And here was my response:

Well there are two things you can do. You can drill the holes after finishing, or you can plug the holes with something. But both of those have some issues. Here’s what I would do. After applying the poly, I would get a few Q-tips and I would very carefully clean out the poly. Well, to be more accurate you aren’t really cleaning it out. You are more or less spreading the poly inside the hole and essentially sealing it up. At the most, the shelf pins will be a little tight, which is never a bad thing. Hope that helps.

Marc's Finishing Quick Guide cover

Free from Marc

Marc’s Finishing Quick Guide

The finishing mistakes Marc sees most, in one printable guide. Big, easy to read type, made to tape to the shop wall.

  • Picking the right finish for the job
  • Scratches that show up after the finish goes on
  • Blotch control
  • Real dry, recoat and cure times
  • Rough final coats
  • Why switching products usually isn’t the fix

Thanks! Check your inbox, the guide is on its way.

Something went wrong. Please try again.

We will email you the guide. Unsubscribe any time.

Wood Finishing in Practice

Want to watch it done? Wood Finishing in Practice

11 Guild lessons, over 7 hours: oils, hardwax oils, wiping varnish, water-based, lacquer, spraying, outdoor and workbench finishes, all on real furniture. $49.

See the lessons

Prefer to read? Marc’s finishing book, $10

Advertisers